The steps to making a three bend saddle are: Measure the height of the object to be saddled. Measure the distance from the end of the conduit to be bent to the center of the object to saddle. Place mark on conduit at distance to center of object. Add 3/16″ to the distance for each inch of saddle required. Click to see full answer. Likewise, how do you measure conduit bends?Measure from the end of the conduit and make a mark at 7 inches to indicate the start of the bend. Slip the end of the conduit into the bender so the 7-inch mark is aligned with the arrow. This 7 inches, plus the “Stubs 5 to arrow” will give you the total horizontal run of 12 inches, including the bend.Secondly, how do you find the center of a bend? The level or straight edge is then placed along the other side of the bend, similar to the placement for the first line. A second line is then drawn on the conduit along the edge of the level or straight edge. If the bend in the conduit is small, the two lines should cross. This point is the center of the bend. Also to know, what is the multiplier for a 45 degree offset? Mathematics of the Offset Bend Degree of Bend in Degrees (Angle) Multiplier Shrinkage Multiplier in inches 15 3.9 1/8 22.5 2.6 3/16 30 2 1/4 45 1.4 3/8 How do you bend a pipe accurately? Method 2 Making a Right Angle Bend Bend a test pipe at a 90-degree angle. Find the place where the bend in the pipe starts. Mark the ends of the bend with a permanent marker. Lay the pipe against the square again to find the length of the pipe in the bend. Find the place on your bending die where the bend begins.

ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZpmeppRirm5%2FjKmmoqakYsCisMOlnGahnmKAboCMnqStZw%3D%3D